Small Farmer's Journal

or Subscribe
NYFC Bootstrap Videos The Golden Yoke

NYFC Bootstrap Videos: The Golden Yoke

by Andrew Plotsky and the National Young Farmers Coalition

I couldn’t have been happier to collaborate with the National Young Farmers Coaltion again when they called up about being involved in their Bootstrap Blog Series. In 2013, all of their bloggers were young and beginning lady dairy farmers, and they invited us on board to consult and collaborate in the production of videos of each farmer contributor to the blog series.

We helped to compile a nimble rig of video gear that we could send around to each of the five farmers, whereupon we compiled a ‘beginner’s guide to filmmaking & cinematography’ and helped to coach the farmers in best practices of filming themselves on their farms. Once they’d collected breathtaking and dynamic footage, they sent an external hard drive back to us and we cut together these films.

A Farmrun Production by Andrew Plotsky

Spotlight On: Equipment & Facilities

Champion No.4 Mower Reaper

The Champion No. 4 Combined Mower and Self-Raking Reaper

by:
from issue:

The project for the winter of 2010 was a Champion No. 4 mower made sometime around 1878 by the Champion Machine Works of Springfield, Ohio. The machine was designed primarily as a mower yet for an additional charge a reaping attachment could be added. The mower was in remarkably good condition for its age. After cleaning dirt from gears and oiling, we put the machine on blocks and found that none of the parts were frozen and everything moved.

McCormick-Deering All Steel Corn Sheller

McCormick-Deering All-Steel Corn Sheller

from issue:

To obtain the best results in shelling, the machine should be run so that the crank makes about forty-five (45) revolutions per minute or the pulley shaft one hundred and seventy-five (175) revolutions per minute. When driving with belt be sure that this speed is maintained, as any speed in excess of this will have a tendency to cause the shelled corn to pass out with the cobs. The ears should be fed into the sheller point first.

The Horsedrawn Mower Book

Removing the Wheels from a McCormick Deering No. 9 Mower

How to remove the wheels of a No. 9 McCormick Deering Mower, an excerpt from The Horsedrawn Mower Book.

The Milk and Human Kindness Stanchion Floor

The Milk and Human Kindness: Plans for an Old Style Wooden Stanchion Floor

by:
from issue:

The basic needs that we are addressing here are as follows: To create a sunny, airy (not drafty), dry, convenient, accessible place to bring in our cow or cows, with or without calves, to be comfortably and easily secured for milking and other purposes such as vet checks, AI breeding, etc. where both you and your cow feel secure and content. A place that is functional, clean, warm and inviting in every way.

Basil Scarberrys Ground-Drive Forecart

Basil Scarberry’s Ground-Drive Forecart

by:
from issue:

I used an ’84 Chevrolet S-10 rear end to build my forecart, turn it over to get right rotation, used master cylinder off buggy and 2” Reese hitch, extend hitch out to use P.T.O. The cart is especially useful for tedding hay. However, its uses are virtually unlimited. We use it for hauling firewood on a trailer, for pulling a disc and peg tooth harrow, for hauling baled hay on an 8’ x 16’ hay wagon, and just for a jaunt about the farm and community.

John Deere No 12A Combine

John Deere No. 12-A Straight-Through Combine

from issue:

It is only natural for the owner of a new combine to want to try his machine as early as possible. This results in most new combines being started in the field before the crop is ready for combining. As soon as a binder is seen in the neighbor’s field, the urge to start becomes uncontrollable. When grain is ready for binding, it is not ready for straight combining.

Mowing with Scythes

Mowing with Scythes

by:
from issue:

Scythes were used extensively in Europe and North America until the early 20th century, after which they went out of favor as farm mechanization took off. However, the scythe is gaining new interest among small farmers in the West who want to mow grass on an acre or two, and could be a useful tool for farmers in the Tropics who do not have the resources to buy expensive mowing equipment.

A Pony-Powered Garden Cart

A Pony-Powered Garden Cart

by:
from issue:

One of the challenges I constantly face using draft ponies is finding appropriately sized equipment. Mya is a Shetland-Welsh cross, standing at 11.2 hands. Most manure spreaders are big and heavy and require a team of horses. I needed something small and light and preferably wheeled to minimize impact to the land. My husband and I looked around our budding small farm for something light, wheeled, cheap, and available, and we quickly noticed our Vermont-style garden cart.

Disc Harrow Requirements

Disc Harrow Requirements

by:
from issue:

One of the most important requirements is disc blade concavity, that is, correct concavity. Further along we set forth the purposes of disc concavity. We feel it is important enough to devote the extra time and words in a discussion of the subject, because seldom is disc concavity talked about, and very few know that there is difference enough to cause good and bad work.

Portable Poultry

Portable Poultry

An important feature of the range shelter described in this circular is that it is portable. Two men by inserting 2x4s through the holes located just below the roost supports and next to the center uprights can easily pick up and move it from one location to another. Frequent moving of the shelter prevents excessive accumulation of droppings in its vicinity which are a menace to the health of the birds. Better use will be made by the birds of the natural green feed produced on the range if the houses are moved often.

Geiss New-Made Hay Loader

Gies’ New-Made Hayloader

by:
from issue:

I was sitting on a 5 gallon bucket staring at the hayloader. I had a significant amount of time and money invested. My wife, the great motivating influence in my life, walked up and asked what I was thinking. I was thinking about dropping the whole project and I told her so. She told me that it had better work since I had spent so much money and time on it already. She doesn’t talk that way very often so I figured I had better come up with a solution.

I Built My Own Buckrake

I Built My Own Buckrake

by:
from issue:

One of the fun things about horse farming is the simplicity of many of the machines. This opens the door for tinkerers like me to express themselves. Sometimes it is just plain nice to take a proven design and build one of your own. Last spring I did just that. I built my own buckrake. I’m proud of the fact that it worked as it should and that my rudimentary carpentry skills produced it.

Center Cut Mower

Center Cut Mower

by:
from issue:

The prospect of clipping pastures and cutting hay with the mower was satisfying, but I wondered how I might take advantage of a sickle mower in my primary crop of grapes. The problem is, my grape rows are about 9 feet apart, and the haymower is well over 10 feet wide. I decided to reexamine the past, as many of us do in our unconventional agricultural pursuits. I set off with the task of reversing the bar and guards to lay across the front path of the machine’s wheels.

The Magna Grecia Hoe

The Magna Grecia Hoe

by:
from issue:

Last spring I put a handle on a curious gardening tool I picked up at the FALCI company in Italy. Ashley, our 17-year-old (a seasoned gardener and enthusiastic digging fork user), was first to try it. She came back excitedly in a rather short time with a request: “Call to Italy right away and have them send us more of these.” “These” are the Magna Grecia hoes, popular in the Calabria region of South Italy but, interestingly, known in very few other places.

Parker Soil Pulverizer

Bring Back To Life the John P. Parker Pulverizer

by:
from issue:

Meanwhile, my senior year was approaching fast, and all of us students began to contemplate what our final project would be with a bit of urgency. Our capstone project tasks us with identifying a need for a product or solution, bringing that product through the design phase, then building that product and displaying at the Technical Exposition. So I had the harebrained idea to embark on recreating not only a scale model of Parker’s Pulverizer, but to also recreate the real thing in full-scale, complete with fresh new wheel castings.

McD Lime Spreader

Parts lists and illustrations are included in this comprehensive overview

Building a Community, Building a Barn

Building a Community, Building a Barn

by:
from issue:

One of the most striking aspects of this development is the strength and confidence that comes from this communal way of living. While it is impressive to build a barn in a day it seems even more impressive to imagine building four barns or six, and all the rest of the needs of a community. For these young Amish families the vision of a shared agricultural community is strong, and clear.

Shed and Barn Plans

Below is a short piece from Starting Your Farm, by SFJ editor and publisher Lynn R. Miller. Click the links below to see Chapter One of Starting Your Farm and to view the book in our online bookstore. “You may have purchased a farm with a fantastic set of old barns and sheds. You, on […]

Journal Guide