Mr. Scarberry had come from West Virginia to share, in the purest sense of the word, his implement ideas. His implements were not for sale, they were there for people to see, measure, ask about and enjoy. He wanted it to belong to everyone; he wanted it to be seen and known as his gift to us.
Adjust the hitch down until the heel of the landside rests flat on the bottom of the furrow. The hitch should always be set as high as possible so that the plow will take the ground quickly, but care should be taken to see that the heel of landside runs flat in bottom of furrow. In case the plow has a tendency to run on its nose, the hitch should be lowered slightly until the heel of the landside runs flat in the bottom of the furrow. The position of the draft bars in a sidewise direction should be maintained by moving the hitch adjusting bar out as the bar is tilted downward.
There are four general plans, or methods of plowing fields. These are: (1) to plow from one side of a field to the other; (2) to plow around the field; (3) to plow a field in lands; and (4) to start the plowing in the center of the field.
All other aspects being equal, the primary difference in plowing, comfortably, with a single horse is that the animal walks on unplowed ground immediately adjacent to the previous furrow, rather than in the furrow. This will cause the point of draft at the shoulder to be somewhat higher and will dictate hitching longer and/or higher than with the animal walking down 5 to 8 inches lower in the furrow.
This plow has all original paint. It sat under a tarp. The dark red spots had punched through the tarp. The share points show no wear at all. It has one regular bottom and the left is an Alfalfa bottom. It was no doubt a show room display or demonstration model. Notice the 1/4 bolts threw the rim that held rubber knobs which deteriorated. Original plows were all red but these wheels have never been anything but green. Original evener combination for 2 or 3 horses also was green.